Latch - Hood - Secondary (RWD) (Remove and Replace)

FRT No: 11103202

Removal

  1. Remove the front underhood apron (refer to procedure).
  2. Remove the bolts (x2) that secure the secondary latch to the crossmember (torque 10 Nm).
    Caution: Care must be taken to avoid fasteners falling into open cavity.
  3. Carefully release the secondary latch assembly and then rotate to access the harness connection.
    Caution: Take care not to damage component(s).
  4. Disconnect the harness from the latch.
    Note: Components have been removed in this graphic to aid clarity.
  5. Remove the latch assembly from the vehicle.

Installation

Installation procedure is the reverse of removal, except for the following:
  • Apply approximately 0.06 grams of RheoGel TEK676 grease to the areas shown.