Fan - Condenser - RH (Remove and Replace)

FRT No: 18201602

Removal

  1. Remove the front wheel arch liner (refer to procedure).
  2. If equipped, release the bolts (x2) that secure the front bumper support bar (torque 11 Nm). Remove the bar from the vehicle.
  3. Disconnect the fan motor electrical connector.
  4. Remove the bolts that secure the fan to the body:
    • Rear Wheel Drive: 4 bolts on the bottom of the fan
    • Dual Motor: 4 bolts on top of the fan
  5. Remove the bolts (x4) that secure the fan assembly to the condenser (torque 6 Nm).
  6. Carefully separate the fan housing from the condenser, and remove it from the vehicle.
  7. Remove any debris collected in the condenser and fan housing.

Installation

Installation procedure is the reverse of removal.
Note: Clean the affected areas before installation.