Tail Light Assembly (Non-Motorized Charge Port) - LH (Remove and Replace)

FRT No: 17402102

Special tool required for this procedure:

Supplier Part Number Description
Tesla 1054190-00-A Feeler Gauges

Removal

  1. Open the charge port.
  2. Remove the rear trunk side trim (refer to procedure).
  3. Remove the nuts (x3) that secure the tail light assembly to the quarter panel (torque 2.5 Nm).
  4. Disconnect the harness and remove the tail light assembly.

Installation

Installation procedure is the reverse of removal, except for the following:

Insert a 1 mm feeler gauge between the body and the base of the tail light. While holding the feeler gauge in place, tighten the nuts in the order shown (torque 3.5 Nm).