Actuator - Latch - Hood - LH (Dual Motor) (Remove and Replace)

FRT No: 11103702

Removal

  1. Remove the ankle catcher (refer to procedure).
  2. Remove the LH and RH condenser ducts (refer to procedure).
  3. Remove the plastic rivets (x3) that secure the center louver assembly.
    Note: The following image shows the center louver assembly from the rear.
  4. Carefully release the radiator assembly and let it hang down.
    Note: This allows access to the screws (x2) that secure the actuator.
  5. Remove the hood latch cable (refer to procedure).
  6. Disconnect the electrical connector from the actuator.
  7. Remove the screws (x2) that secure the actuator (torque 2.5 Nm).
  8. Remove the actuator from the vehicle.

Installation

Installation procedure is the reverse of removal.