Door Glass - LH - Rear (Remove and Replace)
Removal
-
Remove door inner belt glass seal
(refer to procedure)
-
Remove adhesive patches (x3) from glass access openings.
-
Remove screws (x2) securing door access panel (torque 4 Nm).
-
Remove access panel.
-
Lower door glass and align with opening in door panel.
-
Loosen but do not remove clamp nut securing door glass to regulator (torque 7.5 Nm).
-
Using a suitable tool, depress clip and pull leading edge of glass vertically to release from regulator clip.
-
Remove door glass.
Installation
-
Installation procedure is the reverse of removal, except
for the following:
-
Cover all door panel openings with waterproof adhesive tape.
-
Check window alignment and adjust if necessary.