Special Tools - HV Battery Alignment Rods

1026526-00-C

The HV battery alignment rods assist in aligning the HV battery during installation.

Note: This tool is intended to be used by 2 technicians.

To use the alignment rods:

  1. Position the table under the vehicle until the bolt holes in the battery and vehicle are roughly aligned. Do not lock the casters on the lift table at this time.
  2. Identify the bolt holes on the front right and back left of the battery to use with the alignment rods.
  3. Insert the alignment rods through the bottom of the bolt holes so the tapered end points towards the underside of the vehicle.
  4. Lower the vehicle until it is approximately 12 in (30 cm) above the battery.
  5. Insert the alignment rods into the corresponding bolt holes on the vehicle.
  6. Adjust the lift table until both alignment rods are straight.
  7. Lower the vehicle until the battery Rapid Mate makes contact with the vehicle Rapid Mate.
  8. Remove the alignment rods.
    Note: The alignment rods can be stored on the magnetic strips on the underside of the battery lift table.