PCB - Door - Exterior Handle - Rear - LH (Remove and Replace)

FRT No: 11455702

Removal

  1. Remove fork and control link for acces (refer to procedure)
  2. Remove screws (x3) securing PCB to housing (torque 1.5 Nm).
  3. Release PCB pressure sensor from housing and disconnect wiring.
  4. Remove assembly.

Installation

  1. Installation procedure is the reverse of removal, except for the following.
  2. Clean mating fact of PCB touch sensor and housing.
  3. Position PCB to housing and secure with two screws. Connect the PCB wiring connector.
  4. Remove adhesive backing strip from sensor and secure to housing.