Finisher - Floor - Center Console (Remove and Replace)

FRT No: 15192202

Special tool required for this procedure:

Supplier Part Number Description
Tesla 1065399-00-A Skin Wedge Tool

Removal

  1. If equipped, remove the drop in center console assembly (refer to procedure).
  2. Inspect the skin wedge tool:
    • If the tapered end of the tool is not already wrapped with anti-abrasion tape, cut a 2 in (50 mm) piece of anti-abrasion tape (1003224-00-A or equivalent) and wrap the curved end of the tool.
    • If the tapered end of the tool is already wrapped with tape, continue this procedure.
    Bottom of tool Top of tool
  3. On both sides of the vehicle, insert the curved end of the tool under the rear of the floor finisher so the taped side presses against the center console.
  4. Gently pry against the center console until the Dual Lock on the underside of the floor finisher is released.
  5. Lift the rear of the floor finisher to release the Dual Lock on the front of the floor finisher.
  6. Remove the floor finisher from the vehicle.

Installation

Installation procedure is the reverse of removal.