Door Glass - RH - Rear - Adjust

FRT No: 11500400

Removal

  1. Remove door trim pad (refer to procedure)
  2. Partially lower glass for access to glass clamp.
  3. Remove water proof tape for access to adjustment clamp.
  4. Loosen but do not remove clamp nut securing door glass to regulator (torque 7.5 Nm). This allows glass to move fore and aft.
    Caution: Take care not to damage component(s).
  5. Remove plugs (x2) from bottom of door covering regulator adjustment nuts
  6. Loosen nuts (x2) securing regulator adjustment, inboard and outboard to seal (torque 10 Nm).
  7. Align door glass to create best fit condition, torque tighten glass clamp and regulator lower adjusters.

Installation

  1. Installation procedure is the reverse of removal, except for the following:
  2. Cover openings with waterproof adhesive tape.
  3. Check glass for smoothness of operation and seating to body opening seals, re-adjust if necessary.