Examine all grease on the cable for contamination such as dirt, sand, or debris.
If any contamination is present, remove all grease and apply new grease.
-
Place the bullet end of the cable into the guide tube and route the cable
into the roof track, leaving enough room at the end of the cable to secure
the rear link to the shoe.
Caution: Apply lubrication to all surfaces.
Caution: If the shoe is worn or damaged, replace it.
-
Secure the link to the shoe.
-
Move the link and cable through their full range of motion to ensure that
it can move freely.
-
Install the rear stop screw.
-
Move the link to its rearmost position.
-
Install all components that were removed for access.
-
Perform a panoramic roof calibration (refer to
procedure).