Handle - Exterior Release - Door - Rear - LH (Remove and Replace)

FRT No: 11452002

Removal

  1. Remove regulator assembly (refer to procedure)
  2. Make sure exterior release handle is fully retracted.
  3. Disconnect handle harness connector.
  4. Remove nuts (x4) securing door release assembly to reinforcement (torque 9 Nm).
  5. Carefully release door handle assembly from door outer panel and disconnect handle harness connector.
    Caution: Take care not to damage component(s).
    Caution: Protect exterior paint surfaces during this procedure.
  6. Remove exterior release handle assembly from door.
  7. Remove door handle rear seal.
  8. Remove screws (x4) securing handle grip backplate and remove (torque 2 Nm).
  9. Release LED from door grip.
  10. Remove door grip from fork.

Installation

Installation is the reverse of removal, except for the following:

  • Install the grip and back plate on the new handle assembly before reinstallation.
  • Use Toolbox to update or redeploy the firmware:
    • If the vehicle is not running the latest firmware, run the "Vehicle Firmware Update" procedure.
    • If the vehicle is running the latest firmware, run the "Firmware Redeploy" procedure.
  • After installation, check operation of replacement door handle.