Seat Assembly - 3rd Row (Remove and Replace)

FRT No: 13060102

Removal

  1. Open both rear doors and the liftgate.
  2. Move the 2nd row seats into "Easy Entry" mode.
  3. Remove the trunk load floor.
  4. Carefully lift the front of the 3rd row seats to release the clips (x3) that secure them to the body of the vehicle.
  5. Pull the trunk floor carpet towards the rear of the vehicle to gain access to the connectors on the rear of the 3rd row seats.
    Note: Do not remove the trunk floor carpet entirely.
  6. Disconnect the electrical connectors (x2).
  7. Remove and discard the bolts (x4) and washers (x4) that secure the front of the 3rd row seats to the body of the vehicle (torque 34 Nm).
    Note: Components have been removed in this graphic to aid clarity.
  8. Remove and discard the bolts (x4) and washers (x4) that secure the rear of the 3rd row seats to the body of the vehicle (torque 34 Nm).
    Note: Components have been removed in this graphic to aid clarity.
    Note: The bolts have adhesive patch material. If they are difficult to remove, perform the following to melt the adhesive patch material using an inductive heater:
    Warning: Persons that have a pacemaker or any other kind of electronic or metal surgical implant must stay at least 1 m (3 ft) away from the inductive heater while it is in use.
    Warning: Remove all metallic items (such as coins, keys, electronics, and tools) from pockets before using the inductive heater.
    Warning: Ensure that there is a properly-maintained fire extinguisher in the work area before using the inductive heater.
    Warning: Use the inductive heater in a well-ventilated area.
    1. Move any adjacent wiring harnesses away from the work area.
    2. Position the heater coil around the bolt, then heat the bolt for 20 seconds.
    3. Allow the bolt to cool for 2 minutes.
      Warning: The inductive heater coil, bolt, and adjacent areas will be extremely hot.
    4. Remove and discard the bolt.
    5. Use a coated straight flute cut tap to chase the threads.
      Note: Do not lubricate the tap.
      Note: Start the tap by hand. Once the tap is fully engaged in the threads, a tap handle can be used for additional leverage.

Note: The following step requires an assistant.
Note: Wrap seat frame components with shop cloths to avoid damaging interior trim panels during seat removal.

  1. Remove the 3rd row seats from the vehicle.

Installation

Installation procedure is the reverse of removal, except for the following:

  1. Transfer the lower seat cushion to the new 3rd row seat frame, if necessary:
    1. Disconnect the seat cushion harness connectors from the seat electrical harness.
    2. Using a flathead screwdriver, insert and gently pry to the right while pushing the cushion upward to release the cushion. Repeat this step for all three areas.
    3. Transfer the seat cushion to the new seat frame.
    4. Connect the seat cushion harness connectors to the new seat frame electrical harness.
  2. Move the 2nd row seats back to their original positions.
  3. Ensure that the 3rd row seats function properly.