Switch - Brake Light (Remove and Replace)

FRT No: 33252002

Removal

  1. Remove the driver's knee air bag (refer to procedure).
  2. Rotate the brake light switch 45 degrees clockwise and release it from the brake pedal assembly.
    Caution: The brake light switch is a one time use component. Ensure that a new switch is used during reinstallation.
    Caution: Do not push or pull the brake pedal assembly while removing the brake light switch.
  3. Disconnect the brake light switch connector.
  4. Discard the brake light switch.

Installation

Caution: Ensure that the clevis pin is properly secured before reinstalling the brake switch.
  1. Position the brake light switch into the pedal. Rotate the switch 45 degrees counter clockwise to secure it.
    Caution: Do not push or pull the brake pedal assembly while installing the brake light switch.
  2. Connect the brake light switch connector.
    Caution: The brake light switch is a one time use component. Ensure that a new switch is used during reinstallation.
  3. Press and release the brake pedal to turn on the drive rails.
  4. Verify the correct operation of the brake lights.
  5. Reinstall the components removed for access.