Brake Rotor - Front - LH (Remove and Replace)

FRT No: 33010102

Warning: If the vehicle has air suspension, activate "Jack" mode on the touchscreen before raising and supporting the vehicle.

Special tool(s) required for this procedure:

Supplier Part Number Description
Tesla 1082171-00-A S-hook

Removal

  1. Remove the front wheel (refer to procedure).
  2. If the brake pads are being replaced, remove them from the caliper (refer to procedure).
    Note: If the brake pads are not being replaced, continue this procedure.
  3. Note the orientation of the clip that secures the brake hose to the suspension spring module. Release the clip.
  4. Remove the bolts (x2) that secure the caliper to the knuckle (torque 120 Nm).

    View large image.

  5. Release the caliper and use the S-hook to support it.
  6. Remove and discard the screw that secures the rotor to the hub (torque 17 Nm).

    View large image.

  7. Remove the rotor.

Installation

Installation procedure is the reverse of removal, except for the following:
Note: Clean the affected areas before installation.
Caution: Replace all Patchbolt(s).
  1. Ensure that the clip that secures the brake hose to the air spring module is installed correctly.
    Caution: Ensure that the brake hose is aligned correctly with no excessive twist or bends.
  2. Pump the brake pedal at least 5 times to seat the pads against the brake rotor.
    Warning: Always check that the brake pads are seated correctly before driving the vehicle.