Track - Inner - 2nd Row Seat - LH (Remove and Replace)

FRT No: 13020202

Special tools required for this procedure:

Supplier Part Number Description
Tesla 1054190-00-A Feeler Gauges
Tesla 1085692-00-A MX 2nd Row Seat Track Removal Kit

Removal

  1. Remove the sliding carpet assembly (refer to procedure).
  2. Remove the cable ties that secure the harnesses to the track.
    Note: Ensure that new cable ties are installed in the same locations during reinstallation.

    View large image.

  3. Remove the nuts that secure the outer track to the seat (torque 30 Nm).
  4. Remove the track from the vehicle.

Track Alignment

  1. Combine the 6 mm and 5.5 mm feeler gauges to create an 11.5 mm gauge. Insert the gauge against the stop at the rear of the new inner track.

    View large image.

    1 11.5 mm feeler gauge against stop at rear of track
  2. Insert the square bit into the driveshaft hole in the new track, then install the bit into a drill.
  3. Use the drill to move the gearbox rearward until it contacts the feeler gauge.
  4. Remove the square bit from the gearbox, but leave it inserted in the drill.
  5. Insert the 11.5 mm feeler gauge against the stop at the rear of the out track.
  6. Insert the square bit into the driveshaft hole in the seat motor.
  7. Use the drill to spin the motor so that the gearbox on the outer track moves rearward until it contacts the feeler gauge.

Installation

  1. Loosely install the nuts that secure the inner track to the seat, but do not fully torque them at this time.
    Note: The track is fully torqued after the seat is installed in a later step.
  2. Use cable ties to secure the harnesses to the plastic bracket on the track.
  3. Reinstall the sliding carpet assembly (refer to procedure).