Panel - Door Trim - Front - LH (Remove and Install)

FRT No: 15130201

Removal

  1. Fully lower the window.
  2. Open the front door.
  3. Use a trim tool to remove the decorative trim from the door panel.

    View large image.

  4. Remove the rubber cover from the base of the pull cup.
  5. Release the fastener beneath the rubber cover (torque 6 Nm).

    View large image.

  6. Release the fasteners (x3) that secure the trim panel (torque 6 Nm).

    View large image.

  7. Release the clips that secure the trim panel; have an assistant support the trim panel, but do not remove it at this time.
    Tip: Use an inflatable air wedge to release the clips.
    Caution: Do not damage the door module harness that is still connected to the trim panel.
    Caution: These clips are one-time use only.
  8. Disconnect the latch release cable.
  9. Raise the window.
  10. Disconnect the harness that connects to the door module.

    View large image.

  11. Remove the door panel and place it on a flat, soft surface.

Installation

Installation procedure is the reverse of removal, except for the following:
Caution: Replace any broken clips.
  • When reinstalling the manual release cable, ensure that it is routed inboard of the window guide rail.