ECU Box (Remove and Install)
FRT No: 17157001
Remove
Remove the wiper motor assembly
(refer to procedure)
.
Release the fir tree clips that secure the 12V harness to the rear of the fusebox bracket.
View large image.
Release the screws that secure the fusebox bracket to the body (torque 7 Nm).
View large image.
Gently pull the fusebox forward.
Release the 2 clips that secure the fuse box harness.
View large image.
Remove the bolts (x2) that secure the wiper mount bracket to the crossbeam (torque 20 Nm).
View large image.
Remove the nuts (x2) that secure the wiper mount bracket to the studs on the bulkhead (torque 20 Nm).
View large image.
Remove the wiper mount bracket from the vehicle.
If equipped, release the 2 clips that secure LHF air suspension line.
View large image.
If equipped, release the 4 nuts that secure the air suspension reservoir (torque 6 Nm).
If equipped, slide the air suspension reservoir to the LH side of the vehicle, then pull it into the underhood area.
View large image.
Release the harness clip from the ECU box.
View large image.
Release the 3 bolts that secure the ECU box to the firewall (torque 6 Nm). Gently pull the ECU forward but do not attempt to remove it at this time.
View large image.
Release the screw that secures the ECU box cover (torque 3 Nm).
View large image.
Depress the 2 tabs to remove the ECU box cover.
View large image.
Disconnect all harnesses inside the ECU box.
Remove the ECU box from the vehicle.
Installation
Installation procedure is the reverse of removal.