Vent - Motorized - Front Fascia - LH (Remove and Replace)

FRT No: 18503002

Removal

  1. If the vehicle is equipped with 1st generation front fascia applique, remove front fascia applique (refer to procedure) .
  2. Remove ankle catcher foam, if equipped.
  3. Disconnect motorized vent harness connector.
  4. Remove screws (x3) securing vent to fog lamp and front fascia assembly (torque 1 Nm).
  5. Release vent from front fascia static louvers (x2).
  6. Remove vent from front fascia assembly.
    Note: Clean the affected areas before installation.

Installation

  1. Installation procedure is the reverse of removal, except for the following.
  2. If fog lamp is disturbed during vent removal check alignment after fascia installation. Via access hole in chin spoiler, adjust as necessary.