Sensor - Radar - Front (Remove and Replace)

FRT No: 17201502

Removal

  1. Remove the front fascia (refer to procedure).
  2. Remove the radar sensor gasket.
    Note: The flaps on each side of the radar sensor gasket are secured by double-sided tape.
  3. Use a trim tool or flathead screwdriver to gently pry up the tab on the top of the inner bracket. Gently release the radar sensor from the bracket.
    Caution: The radar sensor is still connected by a harness. Do not attempt to remove the radar from the vehicle at this time.
  4. Disconnect the harness on the bottom of the radar sensor.
    Caution: There is little slack in the harness; do not damage the connector.
  5. Remove the radar sensor.

Installation

Installation procedure is the reverse of removal, except for the following:
  • Replace the double-sided tape on the inboard side of the flap on each side of the radar sensor gasket before installing.
  • Calibrate the front radar sensor (refer to procedure).