Actuator - Mode (Remove and Replace)

FRT No: 18102202

Removal

  1. Remove IP carrier (refer to procedure)
  2. Disconnect duct temperature sensor harness connector.
  3. Remove screw securing duct to HVAC assembly and position duct aside (torque 1 Nm).
  4. Disconnect actuator harness connector.
  5. Remove screws (x3) securing mode actuator to HVAC assembly (torque 1 Nm).
  6. Note installed position of secondary flap link prior to removal.
  7. Remove air distribution mode flap actuator.
    Caution: Take care not to damage component(s).

Installation

  1. Installation procedure is the reverse of removal, except for the following:
  2. Ensure secondary flap link is in correct position prior to installing actuator.