Shield - Dust - Brake - Front - LH (Remove and Replace)

FRT No: 33011602

Warning: If the vehicle has air suspension, activate "Jack" mode on the touchscreen before raising and supporting the vehicle.
Note: This procedure describes how to remove and replace the front dust shields. For instructions on how to retrofit the 2nd generation dust shields, refer to procedure 33012006 (refer to procedure).

Removal

  1. Remove the brake rotor (refer to procedure).
  2. Remove the screws (x2 or x3) that secure the front brake dust shield to the knuckle (torque 8 Nm).
    Note: Components have been removed in this graphic to aid clarity.
  3. Remove the front brake dust shield.

Installation

Installation procedure is the reverse of removal, except for the following:
Note: Clean the affected areas before installation.