Applique - Fascia - Front - 2nd Generation (Remove and Install)

FRT No: 10011301

Note: This procedure describes how to remove and install the 2nd generation front fascia applique. If the vehicle is equipped with a 1st generation front fascia applique, refer to procedure 10011402 (refer to procedure).

Removal

  1. Use a trim tool to release the front fascia applique.
    Caution: Take care not to damage component(s).
  2. If installed, disconnect the parking sensor connectors (x2).

Installation

  1. If applicable, connect the parking sensor connectors (x2).
  2. Line up the clips (x7) on the front fascia applique with the corresponding holes in the front fascia bright carrier.
  3. Press both sides of the front fascia applique towards the front fascia bright carrier to engage the clips.
  4. Apply pressure around the perimeter of the entire front fascia applique to ensure that all of the clips are secure.