Press Sensor - Door - Exterior Handle - Rear - LH (Remove and Replace)
Removal
-
Remove door handle for access
(refer to procedure)
-
Position handle assembly on a soft working surface.
-
Remove door handle rear seal.
-
Remove cable ties securing door pressure sensor and motor wiring.
-
Remove press sensor screw.
-
Release door press sensor wiring connector.
-
Using a suitable flat blade, release double sided tape and remove the sensor from the fork.
Installation
-
Installation procedure is the reverse of removal, except for the following.
-
Clean mating face of fork
-
Remove backing tape from sensor and attach to fork.
-
Install door press sensor fixing screw engaging the first ten threads.