Air Line - Air Suspension - Valve Block to LH Front Air Spring (Remove and Replace)

FRT No: 31104002

Removal

  1. Raise and support the vehicle (refer to procedure).
  2. Depressure the air suspension system (refer to procedure).
  3. In the front left wheel well, remove the front portion of the lower wheel arch liner (refer to procedure).
  4. Release the fitting from the front left air spring (torque 5 Nm).
    Caution: Plug the line connection to prevent ingress of moisture or dirt.
  5. Release the air line clips (x2) on the wheel well.
  6. Remove the front aero shield (refer to procedure).
  7. Release the air line clips (x2) on the front trunk area.
  8. Release the fitting from the valve block (torque 3.5 Nm).
    Caution: Plug the line connection to prevent ingress of moisture or dirt.

Installation

Installation procedure is the reverse of removal, except for the following:
  • Install new fittings into the air spring and valve block before installing the air line.
    Note: Ensure that the collet is 4.3 mm from the end of the air line to prevent air pressure restriction.