Forward Junction Box - 2nd Generation (Remove and Replace)

FRT No: 44200702

Warning: Only technicians who have been trained in High Voltage Awareness are permitted to perform this procedure. Proper personal protective equipment (PPE) and insulating HV gloves with a minimum rating of class 00 (500V) must be worn any time a high voltage cable is handled. Refer to Tech Note TN-15-92-003, "High Voltage Awareness Care Points" for additional safety information.

This procedure only applies to vehicles with the 2nd generation High Voltage configuration. The Forward Junction Box is part of the DCDC converter for vehicles with the 1st generation High Voltage Configuration.

Removal

  1. Perform the vehicle electrical isolation procedure (refer to procedure).
  2. Remove the extension box from the underhood storage compartment (refer to procedure).
  3. Release the 4 harnesses from the top of the FJB.
    1 HV Battery heater harness
    2 DCDC converter harness
    3 Compressor harness
    4 PTC heater harness
  4. Release the 12V harness from the left side of the FJB.
  5. Release the 6 bolts that secure the FJB cover (torque 7 Nm). Remove the cover.

Warning: Before continuing, put on high voltage gloves.

  1. Use a small, insulated screwdriver or similar tool to pry open the cover on the front upper left of the FJB.
    Warning: Do not use a metallic tool to open the cover.
  2. Use a multimeter to check voltages between:
    • B+ to ground
    • B- to ground
    • B+ and B-
    Warning: If any voltage reading is more than 10V, the high voltage contactors are not fully opened. Due to the risk of electrocution, contact Service Engineering before performing any further work.
  3. Release the 2 bolts that secure the HV cables to the busbars inside the FJB (torque 4 Nm).
  4. Release the clips that secure the HV cables.
    Note: The O-rings on the HV cables might create suction, which makes the cables difficult to remove. It might require greater than normal force to release the cables.
  5. Release the 3 bolts that secure the FJB to the body (torque 10 Nm). Carefully remove the FJB.

Installation

Installation procedure is the reverse of removal.