Installation procedure is the reverse of removal, except
for the following:
Warning: Replace both sealing
washers.
Caution: Replace all Patchbolt(s).
Caution: Ensure that the
brake hose is aligned correctly with no excessive twist or bends.
Caution: Ensure that the
retaining clip that secures the brake hose to the fixed bracket is oriented
correctly.
Note: Clean the affected areas before
installation.
- Apply an even layer of Silaramic
lubricant (1063021-00-A) to the caliper pad slides. Remove any excess lubricant.
- Apply an even layer of copper
paste between the shim and the backing plate on the brake pads. Remove any paste
that squeezes out after installing the shim.
Caution: Ensure that the brake pads move
freely.
Caution: Do not apply copper paste to the
caliper, seals, or any component other than the shim and backing
plate.
- Perform the brake bleed procedure
(refer to procedure).
Caution: If brake fluid is spilled on a painted
surface, wash off immediately with clean water.
- Pump the brake pedal at least 5
times to seat the pads against the brake rotors.
Warning: Always check that the brake pads are
seated correctly before driving the vehicle.