Mounting - Air Conditioning Compressor (Remove and Replace)

FRT No: 18203202

Removal

  1. Remove the underhood storage unit (refer to procedure).
  2. Recover the A/C refrigerant (refer to procedure).
  3. Perform the electrical isolation procedure (refer to procedure).
  4. Remove the HEPA filter duct (refer to procedure).
  5. Move the coolant reservoir out of the working area:
    1. Ensure that the reservoir cap is fully secured.
    2. Release the 12V harness clip from the coolant reservoir.

      View large image

    3. Disconnect the coolant fluid level sensor electrical connector.

      View large image

    4. Remove the bolts (x4) that secure the coolant reservoir to the front crossmember (torque 6 Nm).

      View large image

    5. Clamp the coolant hose at the rear of the coolant reservoir.

      View large image

    6. Release the locking ring that secures the hose to the coolant reservoir. Release the coolant hose from the nipple on the reservoir.
    7. Plug the coolant hole, then carefully move the reservoir to the LH side of the frunk.

      View large image

  6. Disconnect the compressor HV harness from the forward junction box.

    View large image.

  7. Release the nuts that secure the A/C lines to the compressor (torque 10 Nm).

    View large image.

  8. Release the ground strap from the compressor (torque 8 Nm).

    View large image.

  9. Have an assistant support the compressor. Remove the bolts (x3) that secure the A/C compressor bracket to the front drive unit (torque 10 Nm).

    View large image.

  10. Remove the compressor and bracket from the vehicle as an assembly.

    View large image.

  11. Remove the bolts (x3) that secure the compressor to the bracket (torque 20 Nm).
    Note: Retain the bracket.

    View large image.

  12. Release the compressor from the bracket.
  13. Remove the NVH padding.

Installation

Installation procedure is the reverse of removal.