Door Glass - LH - Front - Adjust

FRT No: 11500100

Preparation

  1. Remove the front door trim panel (refer to procedure).
  2. Temporarily reconnect the front door trim panel harness to the front door module, then fully raise the window.

Inboard/Outboard Adjustment

  1. Loosen the front nuts (x2) that secure the regulator to the door.

    View large image.

  2. Loosen the rear nuts (x2) that secure the regulator to the door.

    View large image.

  3. On the affected corner, hold the nut with an open end wrench and use an allen wrench to adjust the window inboard/outboard.

    View large image.

  4. Repeat the previous step as necessary.
  5. Tighten the nuts (x4) that secure the window motor/regulator assembly to the door (torque 10 Nm).
  6. Reinstall all components that were removed for access.
    Note: If the rear window needs fore/aft adjustment, continue to the "Fore/Aft Adjustment" section.

Fore/Aft Adjustment

  1. Loosen the nut that secures the window to the regulator.
    Note: Do not remove the nut.

    View large image.

  2. Carefully slide the window forwards or backwards as necessary.
    Caution: Take care not to damage component(s).
  3. Tighten the nut that secures the window to the regulator (torque 9 Nm).
  4. Reinstall all components that were removed for access.