Warning: Ensure that 12V
is still disconnected.
-
Position the seat in the vehicle.
-
Reconnect the seat harnesses.
-
Reconnect 12V power.
-
With Toolbox running, re-enter Seat Install
Mode.
-
Reinstall bolts for the rear of the seat in the following order. If any
threads are damaged, discard the fastener and use a rivnut.
- Bolts 1-4: 33 Nm
- Bolts 5 & 6: 22
Nm
-
Install new bolts for the front of the seat in the following order (torque
33 Nm):
-
Use Toolbox to update or redeploy the firmware.
-
Use Toolbox to run the Bitron Seat Diagnostic operation.
-
Use Toolbox to run the Seat Calibration operation.
-
Use Toolbox to run the Occupant Classification Re-Zero operation.
-
Use Toolbox to run the Seat Install operation.
-
Install a new carpet at the base of the seat.
-
Reinstall all components that were removed for access.