Air Line - Air Suspension - Reservoir to Compressor (Remove and Replace)

FRT No: 31104302

Removal

  1. Raise and support the vehicle (refer to procedure).
  2. Depressure the air suspension system (refer to procedure).
  3. Disconnect 12V power.
  4. Remove the underhood storage unit (refer to procedure).
  5. Release the fitting from the compressor (torque 3.5 Nm).
    Caution: Plug the line connection to prevent ingress of moisture or dirt.
  6. Release the air line clips (x3) between the compressor and the reservoir.
  7. Use 2 wrenches to release the fitting from the reservoir: 1 to hold the fitting (12 mm) and 1 to hold the mounting (13 mm) (torque 5 Nm).
    Caution: Plug the line connection to prevent ingress of moisture or dirt.

Installation

Installation procedure is the reverse of removal, except for the following:
  • Install new fittings into the compressor and reservoir before installing the air line.
    Note: Ensure that the collet is 4.3 mm from the end of the air line to prevent air pressure restriction.