Toe Link Assembly - Rear - LH (Remove and Replace)

FRT No: 31032002

Warning: If the vehicle has air suspension, activate "Jack" mode on the touchscreen before raising and supporting the vehicle.

Removal

  1. Raise and support the vehicle (refer to procedure)
  2. Lower rear subframe for access (refer to procedure)
  3. Release clip securing electric parking brake harness to toe link.
  4. Remove bolt securing toe link to knuckle (torque 130 Nm).
  5. Scribe witness lines from bolt cam to subframe, to aid assembly.
  6. Loosen nut and bolt securing toe link to subframe (torque 80 Nm).
  7. Remove bolt from subframe.
  8. Remove toe link.

Installation

  1. Installation procedure is the reverse of removal, except for the following:
    Note: Clean the affected areas before installation.
    Caution: Replace all nylon-insert locknuts.
    Caution: Only fully tighten suspension nuts and bolts when the vehicle is on a 4-post lift and the suspension is in the ride height position.
  2. Transfer vehicle to 4 post lift (refer to procedure)
  3. Perform a four wheel alignment check (refer to procedure)